Installing The Microsd™ Card; Charging Battery - Pantech Element User Manual

Getting Started
Installing the microSD™ card
1. Open the protective cover on the down side of the Element and insert
the microSD™ card into the slot. Note that the left one of the two
covers is dedicated to the SIM card and the microSD™ card. Check
the correct location of the slot on page 13. Ensure that the logo of the
microSD™ card is facing upward.
2. Close the protective cover.
About the microSD™ card
A microSD™ card is a removable flash memory card where you can save
data. Save pictures and contacts, and download applications to the SD
card. A memory space of 16GB is embedded in the Element: you can
expand memory by up to 32GB using the external microSD™ card. It is
recommended that you format the microSD™ card before using the
Element.

Charging battery

Power might not turn on if the battery voltage is too low or battery is
discharged. In that case, charge the battery with the included charger for
more than ten minutes. It is recommended that you charge the battery
fully before you use the Element.
Note A red light blinks once if you press the LOCK/PWR key when there is not
enough battery power to turn on the device. If so, charge the battery for at least
ten minutes before you turn on the power.
1. Open the protective cover on the down side of the Element and
connect the USB connector to the Element. Note that the right
one of the two covers is dedicated to the USB connector and HDMI
port. Make sure to align the connector as indicated in the image.
Otherwise, the charging connector will be damaged and the battery
will not charge.
Correct
2. Connect the other end of the USB data cable to the USB charger.
3. Plug in the USB charger to an electrical outlet. The battery will start
charging.
4. Disconnect the USB charger from the Element when the battery is
fully charged.
10
Incorrect