Table of Contents
Advertisement
MECHANICAL DISASSEMBLY (Continu ed)
18. To remove the platen and paper guide:
1 8.2
Pull the platen washer and shaft sup
porter from the platen shaft.
18.3
Slide the platen to the right to clear the
side frame,
1 8.4
Remove the paper guide screw from
the side frame. Slide the paper guide
to the right to clear the frame.
19.2
Remove the "E" chip from each gear
and lift the assembly from the frame.
19.3
Remove the remaining left frame
screw and slide the frame to release
it from the base.
ASSEMBLY NOTES
To reassemble the printer mechanism, reverse the oraer of disassembly and follow these precautions:
•
The print head must be insulated from the carriage assembly. Check it with an ohmmeter.
•
Lubricate all gears and springs as instructed on page 5.
•
Secure all screws with a self-locking liquid
•
Make adjustments, as required, per the procedure on pages 26 and 27
18.1
Remove the 11
E" clip
shaft.
from the platen
18.2
18.1
19. To remove the gear plate assembly and left side frame:
19.1
Remove the 2 plate screws from the
assembly.
19.1
3$
Advertisement
Table of Contents
