Parts & Assembly - Tristar Products Living Well Pressure Cooker EPC640 Owner's Manual

Instructions For Use
BEFORE THE FIRST USE
1. Before using the Living Well Pressure Cooker for the first time,
wash the inner pot (fig.1, page 8), the Lid (fig.2, page 8) and the
Rubber Gasket (fig.3, page 8 ) with warm soapy water. Rinse with
clean water and dry thoroughly.
2. Make sure the Rubber Gasket (fig.3, page 8 ) is seated properly
inside the Lid. To ensure correct fitting of the Rubber Gasket, fill the
inner Pot ( fig.1,page 8 ) 2/3 full with water and run on Stew Mode
for 15 minutes. Wait 15 minutes, then release pressure by pressing
on the Rapid Release Button ( fig.4, page 8 ) in short bursts. The
Float Valve (fig 6, Page 8) will drop. Let the appliance cool to room
temperature. Pour out the water. Rinse and towel dry the inner Pot.
The Pressure Cooker is now ready for use.
BEFORE EACH USE
For best results, always check that the Pressure Valve (fig.5, page 8),
Float Valve ( fig.6, page 8 ), Rapid Release Button ( fig.4 , page 8),
Safety Valve ( fig. 7, page 8 ) and Rubber Gasket ( fig.3, page 8 ) are
in good working order and that there are no foreign particles blocking
the Valve openings on the underside of the Lid. See CARE &
CLEANING INSTRUCTIONS.
POWER SURGE PROTECTION FEATURE
The Living Well Pressure Cooker has a back-up feature to prevent
malfunction in the event of a power surge. In the event of a system
shut down caused by a power surge, unplug the cooker allow it to
"clear" for 1 hour before plugging it back into the outlet.
7
Instructions For Use (continued)
Parts & Assembly
5.
Pressure Valve
Rapid Release
4.
Button
Lid Handle
2.
Lid Shell
3.
Rubber Gasket
1.
Inner Pot
Outer Pot
Support Ring
LCD
Control Panel
AC Cord
6.
Float Valve
7.
Safety Valve
(located on
underside of Lid)
Housing Handle
Housing
Sensor
Heater Plate
Base
8