Husqvarna 3120XP Operator's Manual page 3

17. Chain catcher
18. Clutch cover
19. Right hand guard
20. Throttle trigger
21. Throttle trigger lockout
22. Decompression valve
23. Combination wrench
24. Chain tensioning screw
25. Operator's manual
26. Transportation guard
27. Air filter cover
28. Lever for extra chain oil
29. Half throttle lock button
30. Product and serial number plate
31. Information and warning decal
32. Oil pump adjustment screw
33. Vibration damping system, 3 units
Symbols on the product
Stop.
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an object.
Warning! Kickback can occur when the
guide bar tip touches an object. A kickback
causes a lightning fast reverse reaction that
throws the guide bar up and in the direction
of the operator. Can cause serious injury.
1527 - 001 - 25.06.2020
This product complies with applicable EC
Directives.
Noise emissions to the environment
according to European Directive 2000/14/EC
and New South Wales legislation "Protection
of the Environment Operations (Noise
Control) Regulation 2017". Noise emission
data can be found on the machine label and
in the Technical data chapter.
Chain brake, engaged (right). Chain brake,
disengaged (left).
Choke.
Decompression valve.
Idle adjustment screw.
High speed needle.
Low speed needle.
Adjustment of the oil pump.
Fuel.
Chain oil.
yyyywwxxxx
Husqvarna Hxx
xx T
xx"
The rating plate shows se-
rial number. yyyy is the
production year and ww is
the production week.
Recommended cutting
equipment in this exam-
ple: Guide bar length xx
in, maximum nose radius
xx Teeth and chain type
Husqvarna Hxx.
3