Safety Recommendations And Warnings - Gavita Pro 1700 LED EU 240 Manual

4

Safety recommendations and warnings

Warning! Carefully read the warnings below before using or working with the product!
•
Always adhere to the local rules and regulations when installing or using the LED fixture.
•
Do not open or disassemble the LED fixture, it contains no serviceable parts inside. Opening or modifying the LED fixture
can be dangerous and will void the warranty.
•
This product may cause interference to radio equipment and should not be installed near maritime safety communications
equipment or other critical navigation or communication equipment operating between 0.45 - 30 MHz.
•
Do not use the LED fixture when either the LED fixture or its power cord are damaged. Replace the power cord only with
original certified cords.
•
Modifications to the cords can lead to unwanted electromagnetic effects, which makes the product not comply with legal
requirements.
•
Do not expose the LED fixture to:
- (ambient) temperatures outside the specified range;
- dust and contamination;
- direct sunlight during use or HID light that could heat up the ballast.
•
Always disconnect the LED fixture from mains before performing any maintenance.
•
Always allow for a cool down period of at least 30 minutes before touching the LED rails. Touching the LED rails when the
fixture is lit or immediately afterwards can result in severe burns!
•
Do not use the LED fixture near flammable, explosive or reactive substances. Do not use sulfur vaporizers or water misters.
•
The installation and use of the LED fixture is the responsibility of the end user. Incorrect use or installation can lead to
failure and damage to the LED fixture. Damage to the LED fixture and electronic circuitry as a result of incorrect installation
and use revokes the warranty.
5 Contents (1)
A. Gavita Pro 1700 LED EU 240
1. LED drivers
2. LED rails
3. Mounting points
B. Sun Grip light hangers (4x)
C. Wieland RST 16i5 female connector
D. Interconnect cable ESA RJ45 - RJ45 3.0 m.
E. Controller cable ESA RJ45 - RJ9 3.0 m.
A2
A1
A
B
1.
AUS plug 240 V CH plug 230 V
3
A3
C
EU plug 230 V UK plug 240 V ZA plug 240 V