Operation; Charging The Battery Pack; Charging Procedure - Yardworks 060-1990-2 Instruction Manual

model no. 060-1990-2 | contact us: 1.866.523.5218
NOTE: Before using the tool, read the instruction book carefully.

CHARGING THE BATTERY PACK

NOTE: The battery in your new tool is not charged when it leaves the plant. Therefore it
must be fully charged before using the first time.
If the battery pack is very hot you must remove your battery pack from the charger and
allow your battery pack to cool first to ambient temperature and then recharging can be
started.
To prevent damage to the battery pack, when charge runs out, please charge the battery to
reach full or no less than half charge before storage.
If the tool will not be used for long periods of time, charge the battery pack every 3-6 months.
CHARGING PROCEDURE (See Fig. A)
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger, the light will begin flashing green to indicate the
charging process has started.
3) When charging is completed, the light will turn solid green. The pack is now fully
charged; unplug the charger and remove the battery pack.
A
WARNING: The charger and battery pack are specifically
designed to work together so do not attempt to use any
other devices. Never insert or allow metallic objects into
your charger or battery pack connections because an
electrical failure and hazard will occur.
WARNING: When battery charge runs out after continuous
use or exposure to direct sunlight or heat, allow time for
the tool to cool down before re-charging to achieve the full
charge.
WARNING: Do not use the
charger outdoors or expose it to
wet or damp conditions. Water
entering the charger will increase
the risk of electric shock.
9