Specifications; Operation; Towing - Toro BC-25 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Hopper Opening
Length
Width
Height
Weight
Engine
Tire Pressure
Fuel Tank Capacity
6 inches (15 cm) maximum
diameter
111 inches (282 cm)
35 inches (89 cm)
81 inches (206 cm)
1056 lbs (478 Kg)
Kohler 725cc, V-Twin, gas
60 psi (413.5 kPa)
5.5 Gal (20.8 L)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
Important: Before operating, check the fuel and oil
level, and remove debris from the machine. Ensure that
the area is clear of people.

Towing

Do not tow over 45 mph (72 km/h)
1. Raise hopper and lock into the up position. Rotate the
chute toward the rear of the machine, lock in position
with the chute locking pin and tighten chute locking
knob (Figure 3).
2. Crank the handle of the lift jack to align the coupler
with the ball of the tow vehicle.
3. Remove the locking pin from the lever, squeeze the
latch lock and lift the lever up to open the coupler
(Figure 5).
1. Tongue
2. Lever in locked position
3. Locking pin
4. Attach coupler to a class I or higher 2 inch (50.8 mm)
ball on a towing vehicle and latch securely.
•
• If coupler does not fit over the ball, turn
adjustment nut one turn counter-clockwise.
•
• If coupler hitch is too loose on the ball, turn
adjustment nut one turn clockwise.
WARNING
Failure to properly engage the hitch ball in
the coupler ball socket and securely lock the
coupler latch mechanism can cause the unit to
become detached from the tow vehicle while
traveling, which may cause serious injury and
property damage.
9
G016604
Figure 5
4. Coupler
5. Safety chain