Table of Contents
Advertisement
2. Rear View
8
SWITCH
HDMI
2
1. AC POWER IN: Connect to an earth 100-240V,50-60Hz AC outlet with the Power Cable.
2. HDMI: Connect it to the HDMI of DVD or other equipment.
3. VGA: For PC display.Connect it to the D-Sub 15 pins analog output connector of the PC.
4. PC AUDIO: Connect it to the audio output terminal of PC.
5. YPbPr: Connect them to the YPbPr video output terminal of DVD.(used in YPbPr source)
6. VIDEO: Connect it to video output terminal of DVD.
L/R in: Connect them to the audio output terminal of DVD(shared with YPbPr)
7. RF: Connect antenna or cable 75 Ohm coaxial to receive TV signal.
8. SWITCH: Switch on or off the power suply.
- To turn on the LCD TV
Press
on the back of the LCD TV to
- Be sure to turn off the power and unplug both units
from the wall outlet before making any connections.
Wall Mounting
The TV is provided with mounting holes for a VESA approved wall mounting bracket(NOT
SUPPLIED). Remove the Two Posi screws holding the base to the base bracket and lift the
base away (do not remove the base mounting bracket). Mount the VESA bracket using
4 x M4 x10 Iso metric threaded screws (not supplied). Do not use screws longer than 10 mm,
damage will occur to the internal parts. Fit the wall bracket securely following the manufacturers
instructions.
Introduction
1 AC POWER IN
VGA
PC
Y
Pb
audio in
3
4
5
Pr
VIDEO
L
Audio in
6
Power on
first.
6
R
RF
7
Power off
Hide quick links:
Advertisement
Table of Contents
