Programming Memory Channels - Icom Amateur IC-2200H Quick Reference Manual

■ Programming memory channels

The IC-2200H has a total of 207 memory channels (including
6 scan edges and 1 call channel) for storing often used oper-
ating frequency, repeater settings, etc.
1. Setting a frequency
In VFO mode, set the desired operating frequency with re-
peater, tone and tuning steps, etc.
2. Selecting a memory channel
Momentarily push [S.MW MW
the desired memory channel.
• "M" indicator and memory channel number blink.
[S.MW MW] [DIAL]
3. Writing a memory channel
Push and hold [S.MW ] for 1 sec. to program.
MW
• 3 beeps sound
• Memory channel number automatically increases when continuing
to push [S.MW ] after programming.
MW
], then rotate [DIAL] to select
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET LOW TONE M/CALL V/ MHz
MONI
QUICK REFERENCE GUIDE
Using the HM-133V
q In VFO mode, set the desired operating frequency, includ-
ing offset direction, tone settings, etc.
w Push [FUNC] then [
A(MW)].
CLR
• "M" indicator and memory channel number blink.
Push ,
MUTE
NAR
MID
LOW
then
LOCK
S ET
e Push [Y Y ]/[Z Z ] to select the desired memory channel.
r Push [FUNC] then push [
gram.
• 3 beeps sound
• Memory channel number automatically increases when continu-
ing to push [ A(MW)] after programming.
CLR
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/ MHz
A(MW)] for 1 sec. to pro-
CLR
VI