Yamaha Magicstomp UB99 Service Manual page 17

3-1-25. END
Push [ON/OFF] SW. The following display appears.
UB99 DIAG ALL OK
PLEASE POWER OFF
Turn off power, and the inspection is now completed.
Finally, perform "4. Factory Set" as follows.
4. Factory Set MODE
Turn off power, and the inspection is now completed.
If you reset UB99 to the factory default setting, all of
the batch contents you saved are erased. Take notes
of the settings, or save the settings on your computer,
if necessary. (See page 22.)
Turn on power while pushing [ON/OFF] SW and
[STORE] SW. The following display appears.
FACTORY SET
NO: [-] YES: [+]
Push [+] SW. The following display appears.
FACTORY SET
SURE? PUSH [STORE]
Push [STORE] SW. The following display appears.
FACTORY SET
NOW FACTORY SET!
Then, the display is changed as follows.
FACTORY SET
COMPLETE!!
The SET is completed.
Then, "5: Opening" display will appear and operation
returns to a normal condition.
At the time of cancellation, the following display
appears.
FACTORY SET
CANCELLED!
5. Opening MODE
In this mode, the following display appears.
MAGICSTOMP
V1.01
Then, the display is changed as follows.
WAIT A MOMENT···
Finally, the display is changed as follows.
U01 △ TUBE DRIVE
-/+ ● GAIN ● MSTR ● TONE
This picture shows an example.
Turn off power and finish the procedure.
UB99
17