Expansion Slots - Biostar A70MD PRO Manual

2.5 Expansion Slots

PEX16_1: PCI-Express Gen3 x16 Slot
• PCI-Express 3.0 compliant.
• Maximum theoretical realized bandwidth of 16GB/s simultaneously per direction, for an
aggregate of 32GB/s totally.
PEX1_1: PCI-Express Gen3 x1 Slot
• PCI-Express 3.0 compliant.
• Data transfer bandwidth up to 1GB/s per direction; 2GB/s in total
PCI1: Peripheral Component Interconnect Slot
• This motherboard is equipped with 1 standard PCI slot. PCI stands for Peripheral
Component Interconnect, and it is a bus standard for expansion cards.
Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion
card into the computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely
seated in the slot.
• Secure the card's metal bracket to the chassis back panel with a screw.
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
A70MD PRO / A68MD PRO / A70MG PRO
Chapter 2: Hardware installation | 11