Mounting The Rock Box; Precautions - Cycle Sounds Rock Box Installation Instructions

the open air as much as possible for accurate reporting.

Mounting the Rock Box

DO NOT OVERTIGHTEN MOUNTING SCREWS! USE LOCK
TIGHT TO MAXIMIZE THREAD HOLD.
IMPORTANT! Use the provided screws AND spacers to mount the
Rock Box to the desired mounting bracket. Use of the provided
screws without the spacers may damage the Rock Box. If using
the Rock Box in a flush mounted application please note you will
need to source screws of the correct length for the particular
mount being used. If the incorrect length screw is used the Rock
Box may be damaged.
The 4-hole AMPS mount pattern on the back of the Rock Box
is the industry standard for mounting devices for aftermarket
applications. The Rock Box AMPS mount pattern is compatible
with all of Cycle Sounds device mounts. To view the full lineup of
mounts and brackets go to www.cyclesounds.com.
Please note it is important to choose a mounting location that
is easily accessible so the driver can use the volume and radio
station presets without stretching.

Precautions:

You may use alternate methods such as Velcro to mount the
Rock Box, but above all make sure your Rock Box is mounted
safely and securely to avoid any damage to the unit while in
use. Any damage to the Rock Box due to improper or insecure
mounting will not be covered under warranty.
IMPORTANT: Always make sure the rubber covers for the AUX
and USB ports are closed when not in use to avoid collecting
moisture or debris. Also make sure to remove devices and
secure the rubber door covers when encountering any
moisture to avoid damage to the unit. Failure to follow these
instructions will result in your warranty being VOID if water
enters the unit due to not properly securing the rubber covers.