Hama 00137289 Operating Instructions Manual page 3

G Operating instruction
Controls and Displays
1. LCD display
2. FUNC = change the display mode
3. SET = set various values
4. UP = change the current set value
5. RESET = reset to factory settings / delete all
stored data
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the
device, please pass these operating instructions on to
the new owner.
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized with
a dangerous voltage of sufficient magnitude to
constitute a risk of electric shock.
Warning
This symbol is used to indicate safety instructions or
to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• Energy cost meter
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial
use only.
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and over-
heating, and only use it in a dry environment.
• Do not drop the product and do not expose it to
any major shocks.
3
• Do not operate the product outside the power limits
given in the specifications.
• Keep this product, as all electrical products, out of
the reach of children!
• Dispose of packaging material immediately accord-
ing to locally applicable regulations.
• Do not modify the product in any way. Doing so
voids the warranty.
Warning
• Only connect the product to a socket that has
been approved for the device. The socket must
be installed close to the product and easily
accessible.
• Only use batteries (or rechargeable batteries)
that match the specified type.
• To avoid damaging the device and to prevent
injuries due to short circuits, do not let the
product come into contact with rain, moisture or
other liquids.
Risk of electric shock
• Do not open the product. Do not continue to
operate the product if it is damaged, which may
be indicated by smoke, odour or loud noises.
Immediately contact your dealer or our service
department (see item "Service and Support").
• Lay all cables so that they do not pose a tripping
hazard.
• The rechargeable battery may only be replaced
by an authorised technician.
4. Proper use
• This energy cost meter allows you to measure the
energy consumption of your electronic devices.
• In addition to the current power and measured
energy amount, the energy cost meter can also
display the mains voltage, current strength, mains
frequency and power factor.
• The values of the energy cost meter are not a suitable
basis for the calculation of power costs for billing
purposes.
5. Starting up/entering the electricity price