Page 8
Electric Outlet Location 9 ” (2 2 .9 c m ) 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o p e n o a r d &...
Page 9
Bottom of anti-tip board is 3–7/8” (9.8 cm) below opening height. Note: Top of unit must be placed firmly under anti-tip board. Note: Dimensions shown for 36” AF/AR model on the left. Reverse mounting boards if units are installed on the right.
Page 10
Electric Outlet Location 9 ” (2 2 .9 c m ) 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o a r d o p e n in g h &...
Page 11
Top View Wall 1–13/16” (4.6 cm) Space if 24” standard cabinet depth is 24” used (61.0 cm) Standard 3/4” Cabinet (1.9 cm) Depth Full End Panel Countertop Overhang Door 2–1/2” (6.4 cm) Offset Top View Wall 1–13/16” 24” (4.6 cm) (61.0 cm) Space if 24”...
Page 12
3 – 1 / 2 ” (8 .9 c m 3 – 1 / 2 ” (8 .9 c m 3 0 ” 4 ” ( 7 6 – 3 / . 2 c ( 5 2 3 6 ” 4 ”...
Page 13
Electric Outlet Location 6 ” (1 5 .2 c m ) 9 ” (2 2 .9 c m ) (2 2 .9 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o p e n o a r d...
Page 14
Electric Outlet Location 6 ” (1 5 .2 c m ) 9 ” (2 2 .9 c m ) 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o p e n o a r d in g h...
Page 15
3 – 1 / 2 ” (8 .9 c m 3 0 ” ( 7 6 . 2 c 3 0 ” 4 ” – 3 / ( 7 6 . 2 c ( 5 2 1 ” ( 2 . 5 B e t 4 c m w e e...
Page 16
3 – 1 / 2 ” (8 .9 c m 3 6 ” ( 9 1 . 4 c 3 6 ” / 4 ” ( 9 1 . 4 c – 3 ( 5 2 1 ” ( 2 . 5 B e t 4 c m w e e...
Page 17
Electric Outlet Location 9 ” (2 2 .9 c m ) 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o a r d o p e n in g h &...
Page 18
Bottom of anti-tip board is 3–7/8” (9.8 cm) below opening height. Note: Top of unit must be placed firmly under anti-tip board. Note: Dimensions shown for 36” AF/AR model on the left. Reverse mounting boards if units are installed on the right.
Page 19
Electric Outlet Location 9 ” (2 2 .9 c m ) 8 2 – 7 / 8 ” (2 1 0 .5 c m a n t i- ) m in t ip b o a r d o p e n in g h &...
Page 20
Top View Wall 1” (2.5 cm) If standard 25” 25” (63.5 cm) standard (63.5 cm) Countertop cabinet depth is used Depth 3/4” (1.9 cm) Full End Panel Door Flush Top View Wall 1” (2.5 cm) If standard 25” (63.5 cm) standard cabinet depth is used...
Page 22
ote: Use excess packaging to protect decorative trim; also, verify that leveling legs are up (0” adjustment). ote: Tilting unit is not required to remove shipping brackets.
Page 23
Wall 2 x 4 Refrigerator Front of unit ote: Make sure power switch and showroom switch are in the “On” Position. Wall 2 x 4 Refrigerator ote: To avoid cabinet damage, place cardboard between cabinets and unit. When moving unit, do not crimp, kink or crush water supply line.
Page 24
ote: DO NOT use an electric device. Overtightening can cause damage. Screw Wall 2 x 4 Refrigerator 90˚ 110˚ 120˚ ote: Shoulder screw should be in 110˚ door opening position.
Page 25
ote: There is a 6 minute delay before the unit starts.
Page 26
COLDEST HIGH ....TEMP TEMP HIDDEN ACTIVATE HIGHER LOWER HIDDEN BUTTON TEMP TEMP TEMP BUTTON CONTROLS MAX FRZ DOOR OPEN COLDEST HIGH ....TEMP TEMP HIDDEN...