Download Print this page

Acer C701 Quick Start Manual page 7

Mixed reality motion controllers


Federal Communications Commission
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the user's
authority to operate the equipment.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
2. For body worn operation, this device has been tested and meets
FCC RF exposure guidelines. When used with an accessory that
contains metal may not ensure compliance with FCC RF exposure
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d'Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible d'en
compromettre le fonctionnement.
RF Radiation Exposure Statement:
For body worn operation, this device has been tested and meets RF
exposure guidelines when used with an accessory that contains no
metal. Use of other accessories may not ensure compliance with RF
exposure guidelines.
Déclaration d'exposition aux radiations RF:
Pour le fonctionnement du corps, ce périphérique a été testé et répond
aux directives d'exposition RF lorsqu'il est utilisé avec un accessoire
qui ne contient pas de métal. Utilisation d'autres accessoires peut ne
pas assurer le respect des directives d'exposition RF.
The following local Manufacturer / Importer is responsible for this
Regulatory model number
Sku name
Name of responsible party:
Address of responsible party: 333 West San Carlos St., Suite 1500
Contact person:
Phone no.:
Fax no.:
October 31, 2018
Disposal instructions
Do not throw this electronic device into the trash when
discarding. To minimize pollution and ensure utmost
protection of the global environment, please recycle.
For more information on the Waste from Electrical and
Electronics Equipment (WEEE) regulations, visit
Motion Controllers
(* is "0-9", "a-z", "A-Z", "-" or blank)
Acer America Corporation
San Jose, CA 95110, U. S. A.
Acer Representative