Advertisement
Quick Links
Advertisement
Summary of Contents for Broadrack Unicorn 17-HD
- Page 1 Unicorn 17-HD Single Rail Console with Modular KVM Switch Quick Installation Guide Rev 1.0...
- Page 2 Unicorn 17-HD QIG Notes 1. Please check all peripherals according the list before installation. To make sure that the whole unit was not damaged and lost during shipping process. If you encounter any problem, please contact your dealer. 2. Before installation, make sure all peripherals and computer have been turned off.
- Page 3 Unicorn 17-HD QIG 4. Bracket attachment x 2 Unicorn 17 bracket attachment 5. Screw (length = 6 mm) x 6 6. Screw x 6 7. Key x 2 Step A (Install Console) 1. Adjust rail until two screws appear. rail two screws 2.
- Page 4 Unicorn 17-HD QIG 3. Adjust rail to fit your cabinet 4. Install front and rear bracket on cabinet. 5. Tight seven screws up. 6. Repeat step 1~5 for the other side. 7. Push console into rails. (Be careful rear box loose when take out console from...
- Page 5 Unicorn 17-HD QIG 8. Unlock and pull rail–lock switch (left and right at the same time) then push console to the end. lock unlock rail-lock switch 9. Install three screws (length = 6 mm) in rear of the console. (Both sides)
- Page 6 Unicorn 17-HD QIG Step B (Replace short bracket) 1. Remove seven screws. 2. Take two original brackets out. original bracket original bracket 3. Put short bracket to rear of the rail. short bracket 4. Install four screws (don’t tight-up) to combine rail, short bracket and bracket attachment.
- Page 7 Unicorn 17-HD QIG 5. Repeat step 1 ~ 4 for the other side. 6. Repeat step 3 ~ 10 of step A to finish the installation. Step C (Replace extended bracket): 1. Loose (Not remove) seven screws. 2. Release six screws.
- Page 8 Unicorn 17-HD QIG 5. Repeat step 1 ~ 4 for the other side. 6. Repeat step 3 ~ 10 of step A to finish the installation.