Advertisement
Quick Links
Advertisement
Related Manuals for Broadrack Unicorn 15
Summary of Contents for Broadrack Unicorn 15
- Page 1 Unicorn 15 / 17 / 19 Console with Modular KVM Switch Quick Installation Guide Rev 1.0...
- Page 2 Unicorn series QIG Notes: 1. Please check all peripherals according the list before installation. To make sure that the whole unit was not damaged and lost during shipping process. If you encounter any problem, please contact your dealer. 2. Before installation, make sure all peripherals and computer have been turned off.
- Page 3 Unicorn series QIG 4. Bracket C x 2 (For cabinet depth 504 ~614 mm. Please refer page 6) Unicorn 15 / 17 bracket C Unicorn 19 bracket C 5. Screw (length = 6 mm) x 6 6. Screw x 8 7.
- Page 4 Unicorn series QIG 3. Adjust rail to fit your cabinet 4. Install front and rear bracket on cabinet. 5. Tight seven rear screws up. 6. Repeat step 1~5 for the other side. 7. Push console into rails. (Be careful rear box loose when take out console from carton.)
- Page 5 Unicorn series QIG 8. Unlock and pull rail–lock switch (left and right at the same time) then push console to the end. lock unlock rail-lock switch 9. Install three screws (length = 6 mm) in rear of the console. (Both sides) 10.
- Page 6 Unicorn series QIG Replace bracket A step (For cabinet depth 828 ~ 1000 mm): 1. Loose (Not remove) seven rear screws. 2. Release six screws. 3. Take rear bracket out. original bracket 4. Adjust rail and input bracket A to rear of the rail then adjust bracket A to fit your cabinet.
- Page 7 Unicorn series QIG Replace bracket B and C step (For cabinet depth is 504 ~ 614 mm): 1. Remove seven rear screws. 2. Take two original brackets out. original bracket original bracket 3. Input bracket B to rear of the rail. bracket B 4.
- Page 8 Unicorn 15 / 17 / 19 Console with Modular KVM Switch Quick Installation Guide...