Frontal Panel Description - Phonic SupremeDI A6200 User Manual

FRONTAL PANEL DESCRIPTION

The six channels on the A6200 all with the same
functions and connections.
1 OUTPUT connector
The balanced output accepts an XLR-F connector, and
sends a processed signal to the mixing console.
2 OUTPUT SIGNAL indicator
This green LED will turn on when a signal greater
than –25dB is present in the signal path.
3 CLIP indicator
This red LED will turn on when a signal of 15dB is
present, as a reminder against possible overload.
4 INPUT IMPEDANCE selector
This selector allows the unit to match the impedance of
the input at 2.2 K, 22 K, or 400 K ohms.
5 GAIN switch
This switch increases the operating range of the input
signal to 0 dB, -20 dB or -40 dB.
PHONIC CORPORATION
1
S I G N A L C L I P
CH1
GND GND
SPLITTER
LIFT LIFT
400K 22K 2.2K
dB
-40 -20 0 HI-CUT HI-CUT
BALANCED BALANCED
8KHz 8KHz
OUTPUT OUTPUT
6 GND LIFT button
Push this button to separate
from that of the OUTPUT, and reduce hum from ground
loops.
7 HI-CUT 8kHz
Push this button to fi lter out frequencies above 8kHz
in the signalt.
8 SPLITTER switch
Push this switch to duplicate the processed signal from
one channel to another (e.g. from CH1 to CH2). The
SIGNAL and CLIP indicators will remain in the
of channels 2, 4, and 6.
9 POWER button
Push this button to turn on the SUPREME DI.
A6200 USER'S MANUAL
FRONTAL PANEL DESCRIPTION
9
S I G N A L L C L I P
SupremeDI
A6200
GND GND
LIFT LIFT
2.2K K
Ohm hm
dB B
HI-CUT HI-CUT
BALANCED BALANCED
8KHz 8KHz
OUTPUT OUTPUT
POWER
the ground of the INPUT
service
Page 7