Initial Setup; Typical Connecting Leads - Phonic SupremeDI A6200 User Manual

INITIAL SETUP

The following is the recommended initial setup for your
A6200.
For channel 1 to channel 6
1 Set the dB level at –40 (dB)
2 Set the impedance level at 400K (ohms)
3 Play the connected instrument to test the output:
A. If the sound output is not loud enough,
adjust the dB level between –20 and 0 (dB)
until the output reaches a suitable volume.
B. If the sound output is not clear, adjust the
impedance level between 22K and 2.2K
(ohms) until the output is satisfactory.
4 If humming appears in the sound output, press the
GND/LIFT button.
5 If the connected instrument is a bass guitar, press
the HI-CUT button to remove frequencies
above 8KHz in the output.
6 If the input signal needs to be sent to two mixers,
press the CH-SPLITTER button to duplicate
the signal. (Please refer to the application for more
information.)
PHONIC CORPORATION
INITIAL SETUP / TYPICAL CONNECTING LEADS

TYPICAL CONNECTING LEADS

On the following page typical connecting leads
have been sorted into seven categories: BALANCED,
UNBALANCED, INSERT CORD, BALANCED
Y-CORD, HEADPHONE SPLITTER, and
UNBALANCED Y-CORD.
The wiring for each of these connectors is detailed in
each category; please refer to the proper group for
your desired application.
All input and output connectors (XLR-male out, 1/4"
phone jack SPL/OUT & OUT, XLR-female input) are
balanced for the A6200 SupremeDI.
A6200 USER'S MANUAL Page 5