Page 1
Ceramic Cook Top – EUC-CD43 User Manual [Revision 3.0 September 2019] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
Ceramic Cook Top – EUC-CD43 Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols: You WILL be KILLED or...
Page 3
Ceramic Cook Top – EUC-CD43 General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must have • The equipment must be serviced or cords, power bars, and electrical fittings for an approved cord and plug and be repaired at authorised service centres by damage or wear before each use.
Ceramic Cook Top – EUC-CD43 Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc., replace them. Flammable Material Hazard...
Page 5
Ceramic Cook Top – EUC-CD43 Slope / Fall Injury Hazard "Slam Dunk" Warning Carbon-Monoxide Hazard Pull Hazard Do not use the product in Be aware that the product Be aware that using the product Do NOT attempt "slam dunk" confined areas or without...
Ceramic Cook Top – EUC-CD43 Table of Contents Safety ................................. 2 Safety Symbols ................................4 Assembly and Set-Up ..........................7 Installation ................................... 7 Fitting Guidelines ................................ 7 Information for Installation Personnel ......................... 8 Inserting and Fixing the Hob ............................8 Seal .....................................
Ceramic Cook Top – EUC-CD43 Assembly and Set-Up Installation Electrical connection Appliances with three-pole cable are set up for operation with alternating current at the voltage and frequency indicated on the rating plate. Look at the connection wiring diagram. The earth conductor is yellow/green.
Ceramic Cook Top – EUC-CD43 Information for Installation Personnel This appliance must be installed only by authorised personnel and in accordance with the regulations of electrical authorities. The wall and bench surfaces must be capable of sustaining temperatures of 95 degrees Celsius.
Ceramic Cook Top – EUC-CD43 NOTES: • The minimum height of any adjacent units (including light pelmets) is 450mm, unless they are manufactured from a material resistant to fire (steel, ceramic tiles for example). • No overhanging surface or rangehood and exhaust system are not permitted within 750mm above burner tops. • Leave at least 50mm clearance between the base of the appliance and a combustible surface.
Ceramic Cook Top – EUC-CD43 Operation • Do not touch the built-in ceramic hob with wet hands or feet. • Do not operate the built-in electric hob when you are bare footed. • Do not let young children operate the built-in ceramic hob.
Ceramic Cook Top – EUC-CD43 Switching ON the Cook Top 1. Press the ON/OFF button (fig. 1) to switch on the appliance. 2. The hob will beep once, and all cooking zone indicators will light up briefly. Indicating that the hob has entered stand-by mode.
Ceramic Cook Top – EUC-CD43 Safety Cut-Off • If one or more of the cooking zones are accidentally left on, a safety cut-off will activate after a certain period of time. The length of time depends on the set power level for that zone.
Ceramic Cook Top – EUC-CD43 Maintenance • Turn off the mains to the equipment before carrying out any maintenance and wait for it cool down. We advise using lukewarm water and detergents to clean enamelled elements. Never use abrasive products.
Ceramic Cook Top – EUC-CD43 Specifications Voltage 220-240V Fuel Type Electric Surface Ceramic Glass Frequency 50/60HZ Features Radiant Hob Total power 6100W Front left element 700/1700W dual zone φ120/180mm Front right element 1200W φ145mm Rear left element 1200W φ145mm Rear right element 1100/2000W dual zone φ145/250x145mm...
Need help?
Do you have a question about the EUC-CD43 and is the answer not in the manual?
Questions and answers