Page 1
Ultrafeed ® Wooden Base #104831 Set Up Instructions 104980*1 Ultrafeed Wooden Base Set Up Instructions...
Page 3
1. Install Rubber Feet • Turn the base upside down. • Place screws through the center of the rubber feet B. • Screw the feet to the base at each of the 4 pre-drilled holes in the base bottom. Be sure the screws are tightened fully so they won’t scrape your tabletop.
Page 4
• Place screw through the countersunk washer and secure using the pre- drilled hole near the storage cavity. 4. Install Your Ultrafeed • Loosen the two set screws on the underside of the sewing machine head that hold the machine to the hinges. Do not remove the screws completely.
Need help?
Do you have a question about the Ultrafeed and is the answer not in the manual?
Questions and answers