Advertisement
Operate Manual
P-number Setting
Setting of the P(pulse)-
number of the wheels
ranges from 2, 4, 8, to 16.
Default setting is 4P.
Speed fine-adjustment
Speed Fine-adjustment
Mode
Ranges 50~250
Default setting is 160.
Setting the speeding value
Turn the Sound Off
Wanring sound will turn off automatically after 30 sec.
(
light still bright)
Press both of
and
button to enter
the function mode. First setting is P-
number. While driving the vehicle to allow
the dashboard of your car to indicate about
40 Km/Hr, record the speed value from the
HUD. After parking of your car, you can
reset the P-number according to the
following conditions.
Default setting of the P-number is 4P.
If the HUD displays about 20 Km/Hr, reset
the P-number as P 2.
If the HUD displays about 40 Km/Hr, there
is no need to reset.
If the HUD displays about 80 Km/Hr, reset
the P-number as P 8
If the HUD displays about 160 Km/Hr, reset
the P-number as P16.
Press both
and
After press
The system will enter the function
mode of speed fine - adjustment. This
function mode is used for adjusting the
displayed speed value to agree with
that of the original dashboard. If the
reading from the HUD is higher, press ▼
button to reduce the value; if the reading
is lower, press ▲ button to increase the
value. Please perform the adjustment
while driving the vehicle over again to
match the speed value.
To confirm your selection, press
There are 5 ranges of speeding value
from 50, 70, 90, 100, 110Km/Hr.
If need to adjust the speeding value to
60Km/Hr, press the
button
twice to enter the first speed value
"50", then press until "60". Press
the left button once will go to the
speeding value adjusting.
*Press both of
and
button
before HUD power on(then turn
on the power)return to default Setting
Press the
button to switch the
Warning Sound On/Off.
When turn off the warning sound, the
horn sign will be put out. Red light only
flash while speeding and put out once
under the speeding value.
5 ranges of speeding value select method
Basic Specification
Dimensions：75 x 44.5 x 17.5 ( L x W x H )ｍｍ
Operating Voltage：DC12V～DC13.5V
Power Consumption：350mA
Max. Brightness：5500 cd/m²(Brightness can be adjusted
accordingto the ambient light source)
Operating Temperature：-20°C ~ 85°C
Attention
(1)Please park the car on the flat floor, turn off the engine
and pull up the hand-brake lever.
(2)Please sort components by kind to avild missing when
take the vehicle apart. Be ware of any reinstalling mistake.
Otherwise, be careful of not damage the vehicle and
components while working.
(3)Please turn off the vehicle power before connecting the
wires to avoid getting an electric shock or short circuit.
(4)Keep the cable away from high temperature and movable
area before connecting wires to avoid it melt by heat or
short circuit.
(6)This product only can be installed on the inner of the
vehicle.
(5)Please use insulating tape or belt to fix the wire to avoid
the sharp metal scarp off the surface of the wire.
Press ▲ & ▼ to select speeding
value.
Press ▲ will show
50~70~90~100~110 in turn, press ▼
will show110~100~90~70~50.
When the projection panel
shows"70"after select, it means the
speeding value is 70Km/Hr.
Advertisement
