Subscribe to Our Youtube Channel
Related Manuals for Open Sesame Door Systems 233
Summary of Contents for Open Sesame Door Systems 233
- Page 1 Installation Guide Booklet Open Sesame Door Systems, Inc. 1933 Davis St. Suite 279 San Leandro CA 94577 510-638-0770 (P) 510-638-2445 (F) info@opensesamedoor.com...
- Page 3 Thank you for your purchase of the Open Sesame Automatic Door System. This product is designed to be durable and provide years of trouble-free service. To ensure the Open Sesame Door System lives up to all expectations, it is important to read and comply with this instruction manual.
-
Page 4: Table Of Contents
Parallel Mount Diagram ........8 (Option C) Model 133 Diagram …............9 Model 233 Diagram …............10 Residential Installation Wiring Diagram …......11 French Door-One Operator Diagram ....... 12 French Door -Two Operators-Two Strikes Diagram …..13 Programming Instructions for Remote Controls ..14... -
Page 5: Recommended Tools For Installation
Recommended Tools for Installation 1. Ladder or Step stool 2. Tape measure 3. Voltmeter (for troubleshooting) 4. Phillips #2 Screwdriver 5. 5/32” or 4mm Allen wrench 6. Wire Cutters 7. Wire Strippers 8. Oscillating Multi Tool (recommended for Strike Installation) 9. -
Page 6: What You Will Find In The Box
What you will find in the box: 1. Door operator with wiring kit and wall transformer 2. Remote Control(s) – if required 3. Electric Strike(s) & Strike Tester – if required - For Electric Strike Installation, refer to separate instructions included with the strike 4. -
Page 7: Selecting Mounting Format/Left Hand Conversion
Selecting the Correct Mounting Format *All doors displayed are viewed from the inside* Option A: Door Mount Option B: Lintel Mount Door Opens Inward Door Opens Outwards (Left Side Hinges) (Right Side Hinges) (Left Side Hinges) (Right Side Hinges) Option C: Parallel Mount Outswing Door + Want a wider opening angle (Left Side Hinges) (Right Side Hinges) -
Page 8: Electric Strike/M233Clutch Adjustment
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Clutch Adjustment (Model 233 only) Adjust force applied to door during manual door opening, as well as powered opening. -
Page 9: Door Mount Instructions (Option A)
For Model 133 Operators: Mount operator at 3” away from the hinges and mount the arm at 13” from hinges (unless it is used for commercial installation). For Model 233 Operators: Mount operator at 4” away from the hinges and mount the arm at 13” from hinges. - Page 10 Door Mount Install Instructions for Inward opening door (Page 2 of 2) 90° 5. Line up the arm with marking you did on the door 6. With the door closed, adjust the arm to 90 jamb so that the middle of the shoe is position where degrees.
-
Page 15: Residential Installation Wiring Diagram
OPEN SESAME Residential Installation Wiring Diagram Using Supplied Wiring Kit (for applications without electric strikes, remove green/yellow wires from telephone jack) ELECTRIC STRIKE CONNECTION: – GREEN ( ) & YELLOW (+) ON JACK RJ-11 TELEPHONE JACK SURFACE MOUNTED (RECESSED JACK CAN BE USED IF HIDING WIRING) WIRE TO BE RAN ON SURFACE, OR... -
Page 18: Current 433 Mhz Units With Green (Green Tipped) Antenna
If the radio receiver light does not flash at all when the remote control button is pushed, the first thing to suspect is a dead battery in the remote control. NOTE: For assistance programming early Model 233 units with GRAY antenna wire, contact Open Sesame. -
Page 19: Earlier 390 Or 315 Mhz Units With Gray Or Purple Antenna
Remote Control Programming Instructions page 2 of 3 For earlier model Open Sesame units with gray (390 MHz) or purple antennas (315 MHz) Programming the LiftMaster 890MAX key chain mini remote: 1. Press and hold the program button on the remote control with a paperclip or safety pin until the LED on the front turns on. - Page 20 Remote Control Programming Instructions page 3 of 3 Miscellaneous Remotes for Earlier 390MHz and 315MHz units - gray or purple antenna wires. Black Test Button Programming Button If using the LiftMaster 892LT 2-Button Remote: Note: If using this remote with older Model 100 operators (sold before Sept 2012), do an erase procedure first by holding down the Open Sesame red program button for 10 seconds.
-
Page 21: Troubleshooting
Troubleshooting Issue Cause Solution No Green (ON) light on the No power from transformer Plug transformer into a different outlet board (no green light on the transformer) Bad Transformer Replace transformer No red light on board Operator is switched OFF Move switch to ON position Realign H Sensor and red dot on disk Unaligned H Sensor and red dot... - Page 22 Door moves slower upon Weather stripping, dragging on Remove anything that might be opening/closing door.. dragging the door. Thick weather stripping may need to be removed Battery Failure Recharge or replace battery Strike does not release door Clutch is engaging and keeps Battery Failure-Turn off operator and latch running so it wont let you open...
Need help?
Do you have a question about the 233 and is the answer not in the manual?
Questions and answers