auto maskin Marine Pro RIO 216 Quick Installation Manual

I/o expansion unit

Advertisement

Quick Links

Manual# 1100373
Quick Installation Guide
RIO 216
I/O Expansion Unit

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Marine Pro RIO 216 and is the answer not in the manual?

Questions and answers

Summary of Contents for auto maskin Marine Pro RIO 216

  • Page 1 Manual# 1100373 Quick Installation Guide RIO 216 I/O Expansion Unit...
  • Page 3 Quick Installation Guide RIO 216 – I/O Expansion Unit Revision Revised November 18, 2015 Revision history: Rev. Date Description Nov.2013 Initial realised revision 18.11.15 Minor updates...
  • Page 4 Copyright © 2010 - 2015 by Auto-Maskin AS. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Auto-Maskin AS. Page ii Quick Installation Guide...
  • Page 5: Table Of Contents

    Table of Content DOCUMENT INFORMATION ........ 1 ..........1 BOUT THIS MANUAL Responsibilities ..........1 ......... 1 RDERING INFORMATION INSTALLATION OF THE RIO 216 ......2 ............2 NTRODUCTION .......... 2 PERATING ONDITIONS ..............2 IRING Power Supply ..........2 Communication to the DCU ......
  • Page 7: Document Information

    Document For updated information, please contact your local distributor. Information Ordering information About this manual The Marine Pro covers a wide range of compatible products within both the This manual has been published 200- and 400 Series. Please visit our primarily for professionals and web site for more information.
  • Page 8: Installation Of The Rio 216

    Installation of Power Supply the RIO 216 DC Power Supply On the RIO 216, connect a DC power supply to pin 6 (positive) and pin 5 This chapter covers installation of the (negative) on the Grey Receptacle. RIO 216 Introduction Ground On the RIO 216, connect ground to pin The RIO 216 is an I/O expansion...
  • Page 9: Communication To The Dcu

    Communication to the The 200 Series The RIO 216 comes preconfigured to communicate with the DCU 410/408 DCU 210/208 wire RIO 216 wire or DCU 210/208 in the Auto-Maskin terminals terminals (Grey Marine Pro range. Receptacle) It can be used together with other RIO 25 (GnD) expansion modules.
  • Page 10: Configuration

    Modbus Reference The RIO 216 is not directly addressed, but is available through the DCU J939 Modbus section as J939 “ Auxiliary IO Number 1” (SPN 702) - “Auxiliary IO Number 16” (SPN 716). For the DCU Modbus I/O list, go to https://docs.google.com/spreadsheet /ccc?key=0Ao77erHB5iQKcFh3NFdLX1 ZoOUZkNWtLUXlranJWUUE&hl=en#gid...
  • Page 11: Pin Layout

    Pin Layout The following tables illustrate the pin layout for the two RIO 216 Deutsch connectors. Quick Installation Guide Page 5...

Table of Contents