Advertisement
INSTALLING THE HOUSING (KIT6A and KIT6AC)
1. Mount the bracket.
Fix the bracket (X) to the mounting surface. Loosen the
screw (A) and unscrew the two screws (B) with a 4mm
Allen key. For an easier access to the screws (B) push the
sunshield forward.
2. Open the housing.
Slide forward the housing body. Disconnect Earth cable. In
order to completely remove the body, pull the pins (C) out
of the rails (D). Feed the cables through the cable glands
(E) on the rear flange.
3. Electrical connections.
Install the camera with the provided screw and insulating
washer. Perform the electrical and video connections
according to the instructions in the camera installation
manual.
4. Close the housing.
To close the housing connect back Earth cable, slide back
the body in its original position and tighten screws (B) and
(A).
4
Advertisement
