Advertisement
14. Position the longer end of the turnaround shaft
between the cylinder stop brackets until the shaft
bracket holes align with the cylinder stop bracket
hole (Figure 8). Make sure the spring rests on the
spring bracket.
15. Mount the cylinder stop brackets to the turnaround
shaft bracket with (2) shoulder bolts, 7/8 inch x
¼" inch thick spacers and flange nuts. Position the
components as shown in Figure 9.
1. Turnaround shaft bracket
2. Spacer
16. Press the floor plate bushing into the hole in the
floor plate (Figure 10).
1. Floor plate
2. Roll pin
3. Turnaround shaft
Figure 9
3. Flange nut
4. Shoulder bolts
Figure 10
4. Floor plate bushing
5. Pedal
6. Pedal pad
17. Place the floor plate w/bushing over the turnaround
shaft and into mounting position (Figure 10). Secure
the floor plate to the frame with the (4) flange bolts
previously removed.
18. Insert the pedal mounting pin into the end of
turnaround shaft (Figure 10). Rotate the pedal until
it is parallel to the floor plate and the pedal holes
align with the shaft hole.
19. Secure the pedal to the shaft with a roll pin
(Figure 10).
20. Affix the pedal pad to the top of the pedal
(Figure 10).
21. Using the dimensions shown in Figure 11, locate and
affix the operation decal to the lower left rear corner
of the steering tower.
1. Operation decal
2. 2–3/4 inches
3
Figure 11
3. 13/32 inch
Advertisement
