Advertisement
7. Reposition the fittings on the #4 and #5 cutting
deck lift cylinders so the hoses are routed toward the
middle of the machine (Figure 5). Cable tie the hoses
together to prevent any interference (2 ties each).
1. Cutting deck lift cylinder fittings and hoses (#5 cylinder
shown)
8. Remove the flange head screws and nuts securing the
#4 and #5 lift cylinder pins to the frame (Figure 6).
1. Lift cylinder pin
9. Remove the lift cylinder pins securing the #4 and #5
lift cylinders to the frame (Figure 6).
10. Position a cylinder stop bracket onto each cylinder
while aligning the mounting holes with the cylinder
mounting holes (Figure 7).
Figure 5
Figure 6
2. Flange head screw
1. Cylinder stop bracket
2. New cylinder pin
11. Secure the cylinder stop brackets and the cylinders
to the frame with new cylinder pins (Figure 7).
12. Secure each cylinder pin to the frame with a 5/16
inch flange nut (Figure 7). Make sure the cylinder
stop brackets pivot freely.
13. Place the washer and spring onto the multi-holed
(shorter) end of the turnaround shaft (Figure 8).
1. Turnaround shaft
2. Washer
2
Figure 7
3. Flange nut
Figure 8
3. Spring
Advertisement
