Advertisement
Quick Links
Assembling the Allegro
Prior to assembly, check the parts and components received against the following list. If you are missing any parts, contact the
Balanced Body customer service department at 1-800-PILATES (1-800-745-2837) in the U.S. and Canada, or +1-916-388-2838
(international).
PREPARE YOUR ALLEGRO REFORMER
If you have purchased an Allegro 14" leg set, we strongly
recommend installing the legs before installing the Tower.
Remove all ropes and risers from the Allegro. If your Allegro
was purchased before February 1, 2004, remove the labels and
backing on the sides. You can order a new label free of charge by
calling 1-800-PILATES (1-800-745-2837 in the U.S. and Canada,
or +1-916-388-2838 (international).
Tower of Power
®
PARTS LIST
Part Number Description
618-024
Tower
TRP0047
Push-through bar (PTB)
GEN9892
T-pin
950-234
Tower Bracket, Right
950-235
Tower Bracket, Left
950-131
Adjustable pulley and knob assembly
212-001
5/32" Allen key, long
SPR9004
Blue trap spring
SPR9002
Yellow trap spring
SPR9461
Long spring, purple
SPR9006
Long spring, yellow
710-010
Roll down bar
101-005
Single cotton loops
210-023
Safety strap with carabiner
DVD8205
Introductory DVD
950-236
Tower lower spring mounts
™
Qty
1
1
2
1
1
2
1
2
2
2
2
1
1 pair
1
1
1
17
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Allegro Tower of Power
Summary of Contents for Allegro Tower of Power
- Page 1 Assembling the Allegro Tower of Power ® ™ Prior to assembly, check the parts and components received against the following list. If you are missing any parts, contact the Balanced Body customer service department at 1-800-PILATES (1-800-745-2837) in the U.S. and Canada, or +1-916-388-2838 (international).
- Page 2 IMPORTANT: READ FIRST NOTE: If you have an original version of the Allegro with the angled corner joints (Serial Number less than 36396), follow these instructions. a. Using the provided 5/32” Allen wrench, loosen and remove the six screws (one on each side of the Reformer and 4 on the head end) that hold the head end of the frame on.
- Page 3 e. Once all four knobs are started tighten them one by one. Bracket ledge Figure C Figure E 4. Make sure both brackets are slid all the way up against the plastic rail caps. Using the provided 5/32” allen wrench, 6.
- Page 4 REPOSITION THE T-PIN TO MOVE: For shipping purposes, the To move a Reformer with Tower a short distance you may Tower is packaged with the be able to lift the head end and roll it on the transport T-pins installed on the inside of wheels as if you did not have a Tower.
Need help?
Do you have a question about the Tower of Power and is the answer not in the manual?
Questions and answers