Advertisement
Quick Links
Champ CF/SD Barcode Scanner
1. Connect your Pocket PC to the computer with Microsoft Active Sync program is
installed.
2. Insert the system CD that come with the barcode scanner into the CD-Rom drive of
your computer and start the setup program.
3. Insert the CHAMP CF or SDIO Barcode Laser Scanner into the Pocket PC Compact
Flash or SDIO Slot.
Note: Make sure you have soft reset your device after software installation before you insert the
card.
4. Clicking Barcode Keyboard Emulator icon on Program Menu.
A beep should sound . Then click the "OK " icon to open Barcode Tigger
You will find
5. Scan Data into Your Application
Quick Start Guide
Hardware (LED Green) – Power on
list on bottom of your PDAs .
1
K:\Products\Packing\BC\BC-PL788-CF,SD\ChampBarcodeScannerQuickStartGuide.doc
Advertisement
Related Manuals for Champ CF Series
Summary of Contents for Champ CF Series
- Page 1 2. Insert the system CD that come with the barcode scanner into the CD-Rom drive of your computer and start the setup program. 3. Insert the CHAMP CF or SDIO Barcode Laser Scanner into the Pocket PC Compact Flash or SDIO Slot.
- Page 2 “ it list on bottom of your PDAs . Click “ Exit “ to close Champ Barcode Keyboard Emulator program. 7. It needs to run the Champ Barcode Keyboard Emulator program again after the Pocket PC is powered off. K:\Products\Packing\BC\BC-PL788-CF,SD\ChampBarcodeScannerQuickStartGuide.doc...
- Page 3 8. Assign a Trigger button on your Pocket PC 8.1 [Start] [Settings] [Buttons] 8.2 From the Button List, select a Pocket PC button to trigger WHANTO Barcode Reader. In the Button Assignment field, select Barcode KeyBoard Emulator. When done, tap ok. 8.3 After the Pocket PC is powered off and power on again, you can press the Trigger Button to restart the Keyboard Emulator program, then scan the barcode.