LEAP Electronics WICE-4MA Quick Reference

WICE-4MA/8MA
WICE
1
Setup WICE hardware and software.
1
AC
Connect the power
supply to the AC
conductor.
2
Connect to the Printer
Port.
8Bit
2
The standard connecting way of the device 8Bit and 16Bit.
! WICE-4MA :
256Kx8Bit ( 27C020 )
The connecting way of the device up to 256Kx8Bit ( 27C020 ).
! WICE-8MA :
512Kx8Bit ( 27C040 )
The connecting way of the device up to 512Kx8Bit ( 27C040 ).
EPROM-POD
& WICE-4MA :
256Kx16Bit ( 27C1024-2048 )
The connecting way of the device 256Kx16Bit ( 27C1024-2048 ).
& WICE-8MA :
512Kx16Bit ( 27C1024-4096 )
The connecting way of the device 512Kx16Bit ( 27C1024-4096 ).
WICE-4M-4096
Quick reference and simple problems solving
16Bit
WICE
3
Setup WICE software.
,
4
According to the following steps, connect PORT A/B
of WICE to the target board that you want to emulate.
Output signal control.
WICE
5
Execute WICE software.
& WICE-4MA :
512 Kx8Bit ( 27C040 )
The connecting way of the device 512Kx8Bit ( 27C040 ).
& WICE-8MA :
1024Kx8Bit ( 27C080 )
The connecting way of the device 1024Kx8Bit ( 27C040 ).
EPROM-POD
'EPROM-POD'
Pin1,Pin31
POD'
,
"EPROM-POD" (Protecting Board) : It only can
protect high voltage damage of Pin1 and Pin31 (7V-
12V). If the other pins had irregular high voltage
(>7V), it might cause the "EPROM-POD" 10
resistor damaged. You can replace it by yourselves
or send it back to us for service.
WICE PORT A / B
PORT A / B
Emulate output PORT A/B.
(7V-12V),
(>7V),
10 SMD ,
Pin
'EPROM-
SMD