Basic Setup - ViewSonic N3752w User Manual

Basic Setup

1. Power on the A/V component you wish to setup, so that you can test codes by
sending power off commands.
2. Refer to the Pre-programmed code tables on page 13-18 and write down the
code number listed.
3. Press and hold the button for the desire device for approximately six seconds.
The top LED will turn on, enter pre-programmed code. LED will blink to indicate
pre-programmed code was captured correctly.
Record the three digit codes for your device here:
TV
DVD
STB
VCR
ViewSonic
LED
Pre-Programmed Code Notes
VPB
WMA
AUD
AUX
11
Device Buttons
N3752w