Advertisement
4
Audio Playback
1.
HearLink PLUS Manual Control
Short press to toggle audio Play/Pause.
Press to increase the volume. A tone is played
when maximum volume is reached.
Press to decrease the volume. A tone is played
when minimum volume is reached.
2.
Bluetooth Headset Remote Control
Manage audio play using the headset's controls.
Short press the multifunction button to toggle
Play/Pause audio.
Press volume up button to increase the volume.
Press volume down button to decrease the
volume.
For BeHear headsets only:
To toggle between two connected audio sources
(e.g., HearLink PLUS and a smartphone),
simultaneously short press the headset's volume
up and volume down buttons.
5
Helpful Information
1.
If you do not hear audio:
§
Ensure that the 'audio out' port of your TV (or other
media device) connected to the HearLink PLUS is
active. For some devices you need to enable the
audio output. Refer to your device's user manual.
§
Toggle the Play/Pause button on the headset or
button on the HearLink PLUS.
2.
Use the HearLink PLUS Bypass mode to maintain the
existing interfaces between your TV and peripheral
audio equipment.
Remove the sticker to expose the RX ports.
Connect the HearLink PLUS TX port to the TV via the
optical or 3.5mm audio cable, and the RX port to a
speaker or other peripheral audio equipment using the
same type of cable as the TX port connection.
To passthrough HearLink PLUS set
its Mode switch to Bypass position,
indicated by
. To restore
connection with the headset set
the Mode switch to TX.
HearLink Plus-QS-EN-Ver02
OPT
AUX
Wired Speaker
TX
Advertisement
