Advertisement
3
Setting Up HearLink PLUS
1.
Connect HearLink PLUS to a power outlet (A) or the TV
set's USB port (B) using the supplied USB power cable.
HearLink PLUS will turn ON automatically.
2.
Ensure that the Mode switch is set
to the TX position.
3.
Connect the HearLink PLUS TX port to the TV (or other
media device) via the supplied optical or 3.5mm audio
cable.
Make sure to remove the plastic protectors from
the optical cable terminals prior to insertion.
The active connection type is indicated by the
illuminated text (
or
OPT
front display panel.
Purchased separately
TX
Remove for
Bypass use
AUX OPT
) on the HearLink PLUS
AUX
4
First Time Connection
1.
Place HearLink PLUS into pairing mode with a short
press on its
button. When in pairing mode the
indicator light will flash quickly.
2.
Place your Bluetooth headset in "pairing" mode. Refer to
the headset's technical documentation for pairing
instructions.
3.
Place the Bluetooth headset close to the HearLink
PLUS device.
4.
When pairing is complete (after 5-30 seconds)
be illuminated on the HearLink PLUS front display
panel.
The
is illuminated to indicate that the Low Latency
LL
APTX-LL Bluetooth CODEC is being used.
Successful connection of the headset is indicated by
the illuminated
on the HearLink PLUS front display
A
panel.
Subsequent connections should be automatic. If not,
for BeHear headsets, a short press on the headset's
Power button should re-establish the connection.
TX
Bluetooth headset
will
TX
Advertisement
