Advertisement
0-40° C Electronic Thermostat with LCD
Display
USER INSTRUCTIONS
Model: THAT040E
TABLE OF CONTENTS
1. Important Safety Instructions
2. Specification Data
3. Controller Guide
6. Product Warranty
1. Important Safety Instructions
• Prior to installing and operating this controller device, read the instructions
carefully and retain for
future reference.
• Indoor use only.
• Ensure the rated voltage is 220-240V.
• Do not remove plug from power socket by pulling the power cord. Always grip plug.
• Do not operate this appliance if the power cord or plug becomes damaged.
• Do not immerse in liquid, as this could create an electric shock hazard.
• Do not reach for an appliance that has fallen into water. Switch off at supply and
unplug immediately.
• Do not operate appliance with wet hands. Always ensure hands are dry before
operating or adjusting
any switch on the product or touching the plug and mains supply connections.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or
instruction concerning use of the appliance by a person responsible for their safety.
2. Specification Data
• Rating: 220-240V ~ 50Hz, 9A IP20
• Maximum load Wattage: 2200W (9 amp).
• Environmental temperature: below 40 degree C.
• Range of pre set temperature is from 0.0 to 40.0 degrees C.
• Dimensions of controller box: 115mm x 90mm x 45mm
• Sensor cord length: 890mm
• AC power cord length: 1.6m
3. Controller Guide
1. Sensor Temperature
2. Setting Temperature
3. Down Button
4. Up Button
5. Set Button
6. AC Socket
7. AC Power Cord
Advertisement
Table of Contents
Related Manuals for Thermofilm THAT040E
Summary of Contents for Thermofilm THAT040E
- Page 1 0-40° C Electronic Thermostat with LCD Display USER INSTRUCTIONS Model: THAT040E TABLE OF CONTENTS 1. Important Safety Instructions 2. Specification Data 3. Controller Guide 4. General 5. Operation Instructions 6. Product Warranty 1. Important Safety Instructions • Prior to installing and operating this controller device, read the instructions carefully and retain for future reference.
- Page 2 8. Sensor Cord 4. General The THAT040E thermostat is designed to operate a heating device up to 9A at a controlled temperature. The heating device is simply plugged into the thermostat and the desired temperature is set. The LCD display shows both the actual temperature at the sensor and the desired set temperature.
Need help?
Do you have a question about the THAT040E and is the answer not in the manual?
Questions and answers