Accessories And Replacement Parts; What If There Are Problems; Disposal; Technical Specifications - Beurer MP 100 Instructions For Use Manual

• Ensure that no water enters the device. If this should happen, reuse the device only when it
has fully dried out.
• Do not submerge the base station and mains adapter in water or any other fluids.

10. Accessories and replacement parts

Replacement parts and wearing parts are available from the corresponding service address
(according to the service address list). Please state the corresponding order number.
Replacement part
1 x Sapphire cone, fine
1 x Sapphire cone, coarse
1 x Sapphire wheel, fine
1 x Sapphire wheel, coarse
1 x Cylindrical cutter
1 x Flame-shape cutter
1 x Sapphire cutter, round
1 x Nail cutter
1 x Felt cone
30 x Single-use attachments made of sandpaper
1 x Protective cap for nail dust
Attachment for using the sandpaper attachments 164.291
Mains adapter

11. What if there are problems?

Problem
Hand-held device will
not switch on.

12. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end
of its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispo-
se of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.

13. Technical specifications

Mains operation:
Input
Output
Average active efficiency
Efficiency at low load (10 %)
No-load power consumption
Dimensions
Weight
Subject to technical changes
Possible cause
Mains adapter not plugged in
No voltage at mains socket
Hand-held device not connected to
base station.
100-240 V~, 50/60 Hz, 0.8 A
15.0 V
≥ 88.22 %
≥ 88.08 %
≤ 0.065 W
22.0 x 23.5 x 11.0 cm
ca. 1.18 kg
Material number
570.64
164.292
Solution
Insert the mains adapter into the
socket.
Check your fusebox.
Connect the hand-held device to
the base station.
2.0 A, 30.0 W
19