Using The Lcd Display; Setting The Timing Mode; Osd And Power Lock Settings - ViewSonic VG910B User Manual

Using the LCD Display

Setting the Timing Mode

Setting the timing mode is important for maximizing the quality of the
screen image and minimizing eye strain. The timing mode consists of the
resolution (example 1280 x 1024) and refresh rate (or vertical frequency;
example 75 Hz). After setting the timing mode, use the OnView
to adjust the screen image.
For the best picture quality set your LCD display timing mode to:
VESA 1280 x 1024 @ 60Hz.
To set the Timing Mode:
Set the resolution: Right-click on the Windows desktop > Properties >
1
Settings > set the resolution.
Set the refresh rate: See your graphic card's user guide for instructions.
2
Do not set the graphics card in your computer to exceed the
WARNING:
maximum refresh rate of 75Hz; doing so may result in permanent damage to
your LCD display.

OSD and Power Lock Settings

• OSD Lock: Press and hold [1] and the up arrow
buttons are pressed the message OSD Locked will display for a few seconds.
• OSD Unlock: Press and hold [1] and the up arrow
• Power Button Lock: Press and hold [1] and the down arrow
seconds. If the power button is pressed the message Power Button Locked
will display for a few seconds. With or without this setting, after a power
failure, your LCD display's power will automatically turn ON when power is
restored.
Power Button Unlock: Press and hold [1] and the down arrow
seconds.
▲
for 10 seconds. If any
▲
again for 10 seconds.
▼
ViewSonic VG910b/VG910s
controls
®
▼
for 10
again for 10
6