Removing From Storage - Toro 20709 Operator's Manual

Note: Fold handle only as illustrated. If
handle is folded in opposite direction
damage will occur to control cables.
3. Loosen knobs securing top handle section to
bottom section and fold top handle section back
towards rear of mower into storage position.

Removing From Storage

1. Unfold handle. See handle assembly instructions
in ASSEMBLY section
2. Check and tighten all fasteners.
3. Remove spark plug (Fig. 4) and spin engine
rapidly using starter to blow excess oil from the
cylinder. Clean spark plug or replace if cracked,
broken or electrodes are worn.
4. Install spark plug and torque to 180 in.-lbs.
(15 ft.-lbs.) (20 N m).
5. Perform recommended maintenance procedures.
See MAINTENANCE section.
6. Fill fuel tank (Fig. 9) with fresh, clean
gasoline/oil mix.
7. Reconnect spark plug wire (Fig. 4).
18