Coleman CO534L-A Owner's Manual page 11

4 . Turn on power to the spa .
5 . Prime the pump .
If spa fails to prime, there could be an air pocket at the suction side of the pump. Follow the priming instructions
on page 10 using the bleeder valve.
6 . Install the fi lter into the fi lter canister.
7 . Let the spa heat up .
When the spa has fi nished priming, the heater will activate.
Put the cover on and let the spa run for two hours.
8 . Adjust water chemistry .
After the spa has run for two hours, test and adjust the water chemistry. See the section on page 18 for
instructions on water clarity.
Coleman Spas (online sales)
®
LTR50001135, Rev. A
When the spa is fi lled to the correct level, turn on the
power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
Your spa will perform a self-diagnostic check and go into
priming mode. When the control panel displays PR, do the
following:
a. Press the JETS button to turn on the pump and let it
run for 10 seconds. The pump should be running in
low speed.
b. Press the JETS buttons again and let the pump run in
high speed for 10 seconds.
c. Press the JETS button again to turn off the pump. The
pump should be left off for 10 to 15 seconds.
d. Repeat steps a through c until water is fl owing through
all the jets and all air is removed from the plumbing.
Make sure the fi lter has soaked at least 30 minutes
before you install it.
9
Coleman logo (white)
<----------