Advertisement
Unit connection
8
Installation information
The cubical unit sections are connected to one another with M8 screws. For
this purpose, the cubes contain bore holes at respective locations.
All small assembly parts and loosely supplied accessory are packed in a
component fitted with an inspection door (preferably fan component). The
respective component is identified by the label "Accessory inside
component".
Before screwing together the cubes, the self-adhesive sealing tape (KG) or
the permanently elastic sealing material (KGW) must be applied to one side.
To ensure maximum sealing, the dimensions shown in the following
illustrations must be observed.
KG
After tightening the connecting screws, the respective loosely supplied frame
capping sections must be assembled and secured to the internal frame corners
(sheet metal screws).
In cases where, for design reasons, the frame capping sections cannot be
removed, respective holes in the frame capping sections will be provided by
the manufacturer. These holes must be sealed with the supplied plastic plug
after the units have been screwed together.
Gigant
KGW
Double frame
capping section
Internal frame corner
Frame capping
section
Hide quick links:
Advertisement
