Table of Contents
Summary of Contents for KleenRite 32506
- Page 1 ® 32506 Upholstery and Drapery Cleaner Model No.: Operator and Parts Manual 32506 – 3 gal Extractor KLEENRITE 1122 MAPLE STREET MADERA CA 93637 U.S.A. FAX: 1-559-673-5725 MNL32506 CUSTOMER SERVICE: 1-800-241-4865 Rev. 00 (08-98)
-
Page 2: Table Of Contents
© Kleenrite Printed in U.S.A distributor or directly from Kleenrite. Kleenrite Equipment is a registered United States trademark This machine will provide excellent service. However, the best results will be obtained at minimum costs i • The machine is operated with reasonable care. -
Page 3: Safety Precautions
Do not handle plugs with wet hands. – Keep cord away from heated surfaces. – Report machin e damage or faulty operation immediately. – Follow mixing and han dling instructions on chemical containers. – Do not mix water and OMS. 32506 (11-98) - Page 4 WARNING: Hazardous Voltage. Shock or local codes and ordinances. Do not remove electrocution can result. Always unplug machine ground pin; if missing, replace plug before use. before servicing. GROUNDED OUTLET (3 HOLE) GROUNDING 32506 (11-98)
-
Page 5: Machine Components
11 liters (3 gallons) of hot water, 60° C (140° F) maximum (Figure 2). WARNING: Do not use OMS cleaning solutions with a flash point of less than 125° F. 5. Add a recommended cleaning chemical. Fig. 1 Fig. 2 32506 (11-98) - Page 6 FOR SAFETY: When using machine, follow mixing and handling instructions on chemical containers. 32506 (11-98) 32506 (11-98)
-
Page 7: Machine Operation Wet-Cleaning
ATTENTION: Excessive foam buildup will cause come on in the 120° F setting. Th is is confirmed fibers to collect on vacuum inlet screen. by the illumination of the green 120° F solvent activated light (Figure Fig. 4 Fig. 6 32506 (11-98) - Page 8 3. Clean vacuum inlet screen when lint collects on it (Figure 6). 32506 (11-98)
-
Page 9: Machine Operation-Dry Cleaning
5. Always wear a respirator. Warning: Do not proceed to clean unless all five conditions are met. 6. Turn on pump and be certain it is primed. 7. Turn on heater in the 120° F setting. 32506 (11-98) -
Page 10: Draining Tanks
MONTHLY MAINTENANCE (Every 80 Hours of Operation) 1. Inspect vacuum and pump motors for excessive arcing. If arcing is present replace them. and insert into end of solution hose and pump into container (Figure 10). FOR SAFETY: 32506 (11-98) - Page 11 2. Inspect machine for water leaks and loose hardware. Repair immediately! 32506 (11-98)
-
Page 12: Trouble Shooting
Plugged spray tips. Clean or replace tips. Improper spray tip size or spray angle. Replace with proper tips. Worn spray tips. Replace spray tips. Solution tank low or empty. Refill solution tank. Faulty solution pump Contact Service Center. 32506 (11-98) -
Page 13: Specifications
HEATER 120 V, 10.4A, 1250 W SEALED WATER LIFT 2350 mm (92.5 in) TOTAL POWER CONSUMPTION 120V, 19.1A, 2292W POWER CORD 7.6m (25 ft) 3/12 DECIBEL RATING 3 METERS (10 FT) FROM <77 db(A) ACHINE ON CARPET SPECIFICATIONS 32506 (11-98)