InVento 500880 Quick Manual page 6

Preparation of the transmitter
1. Remove adhesive strips and remove
the transmitter and the fish mounting in
the direction of the arrows.
4. Use a Phillips screwdriver to open the
battery compartment cover.
Insert 4 x AAA 1.5 V batteries with the
correct polarity and replace the battery
compartment cover.
Charging the RC Mini Shark
Insert the USB plug of the charging cable into the USB
port on your computer (fig. 1). Then insert the charging
plug into the charging socket on the Mini Shark (fig. 2).
The charging LED lights up. The LED will extinguish after
approximately 20 minutes to indicate the Mini Shark
has been completely charged. Maximum operation time
is 15 minutes.
2. Remove the antenna and the
fish from the fish mounting.
Function indicator
5. The function indicator lights
up when any button on the
transmitter is pressed and the
batteries are inserted with the
correct polarity.
6
3. Use a Phillips Screwdriver to
remove the screw on the fish
mounting as illustrated and pick
out the USB charging cable.
6. Insert and tighten the
antenna to the antenna hole on
the transmitter as illustrated.
(fig. 1) (fig. 2)