Advertisement
BASELINE CLOUD NETWORK MODULE-CONFIGURATION GUIDE - BASESTATION 3200
Cloud Network Module Configuration Guide-BaseStation 3200
Setting Up a CN Ethernet Connection
A Cloud Network (CN) Ethernet connection allows your controller or device to automatically obtain an IP address
through the cloud, which enables the connection to the internet. Every time you restart your controller or device, it
retrieves a new IP address.
1.
Plug an Ethernet cable into the Ethernet
1
port on the back of the display board and
plug the other end of the cable into a live
Ethernet jack.
2. On the controller, turn the dial to the
Network position.
3. The Communication Setup option should
be highlighted. If it is not, press Next until
it is highlighted.
Press Enter. The Communication Setup
1.
2
screen displays.
2. In the Comm Type field, press + or – to
select CN_Ethernet.
Press Next to select IP Setup.
1.
3
2. Press Enter. The IP Setup screen displays.
The controller uses the Dynamic Host
Configuration Protocol (DHCP) to establish
the network connection. The DHCP
protocol automatically configures the
network settings. Relevant fields are
masked in gray and completed according
to your own network settings.
14
866 294 5847
|
baselinesystems.com
|
support@baselinesystems.com
Advertisement
