Advertisement
3. ASSEMBLY
3.1. The heater can be free standing on the feet provided or can be wall mounted using the wall mounting brackets .
3.2. Mounting the feet. (Refer to fig.1.) Turn the heater upside down and support it securely. Take one of the feet
and place it onto the underside of the heater in the position indicated in fig.1. The upstanding rim on the top of
the foot should fit neatly into the underside of each side moulding with the notch in the rim of the foot facing
inwards. When the foot is correctly positioned the 4 holes in the foot will line up with the four holes in the
underside of the heater. Fasten each foot down with the self tapping screws provided.
3.3. Wall mounting the heater. The wall mounting kit consists of four wall mounting brackets as shown in fig.6. ( two
left hand and two right hand ) and four 35mm fixing screws with wallplugs. Locate the heater close to a mains
supply socket.
3.5. Sort the wall mounting brackets into two pairs having a right hand and a left hand bracket in each pair. Take one
pair of brackets and mount them to the underside of the heater using self tapping screws as shown in fig.2 and
fig.3. Each bracket should be fixed 60mm in from either end in the pre-drilled holes provided.
3.4. Take the other pair of brackets and fix them to the wall with the wall plugs provided as shown in fig.6. The
hanging slots should be facing upwards and the two brackets should be facing towards each other 486mm apart
as shown in fig.4. The fixings should be at least 800mm above the floor to give a minimum clearance of 100mm
between the bottom of the heater and the floor as shown in fig.5. When the heater is wall mounted the feet are
not required.
3.6. Present the heater to the wall so that the wall mounting brackets enter the two slots in the back of the heater.
Push the heater onto the brackets and allow it to drop into the hanging slots equally on both sides.
3.7. The two lower mounting brackets should now be resting squarely on the wall. If not, rotate them slightly on their
screws until the mounting surface is flat against the wall. Mark the mounting positions on the wall through the
mounting holes. Remove the heater from the upper brackets and drill and plug the wall in the positions marked.
Re-hang the heater on the upper brackets. Fix the lower brackets to the wall with the screws provided.
3.8
To eliminate excess cable lying on the floor it may be necessary to shorten the cable to one short loop.
Remove the plug. Shorten the cable and rewire the plug as shown in section 1.1.9.
fig.1
fig.2
Original Language Version
fig.6
CD2005, CD2005T
fig.3
fig.4
fig.5
Issue: 3 - 13/04/10
Advertisement
