Dell SPR-WL2-MNT Installation Manual page 3

Wall Mounting
This option allows mounting the device on a wall.
Required Tools and Equipment
Two wall-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Wall-mount screws (not included in this package, the type of screw depends on the installation surface)

Suitable screwdrivers (not included in this package)

Wall anchors (optional, not included in this package)

NOTE: The Ethernet ports must be facing down when installing the device on a wall.
Installation Steps
To install the device on a wall:
1. Fasten the wall-mount brackets over the mounting holes on the sides of the device using the M4 x 8 mm
Phillips head screws and a suitable screwdriver (see
Figure 3
2. After choosing a location, mark the points on the wall for the mounting holes.
3. Drill the holes and insert wall anchors if needed.
4. Align the holes of the mounting bracket with the holes on the wall (see
5. Use the appropriate screws to secure the device.
6. Connect the AC power cord to the rear of the device to power up.
Dell Networking SPR-WL2-MNT | Installation Guide
Attaching the Wall-Mount Brackets (W-7205)
Figure 3).
Figure 4).
3