Advertisement
Operation
WARNING:
Protect your eyes and ears. Wear safety glasses with side shields. Wear hearing protection. Employers
and users are responsible for ensuring the user or anyone near the tool wears this safety protection.
1. Check and replace any damaged or worn components on the tool. The safety warning labels on the
tool must also be replaced if they are illegible.
2. Add a few drops of lubricant into air inlet.
3. Install a quick connect fitting to the tool.
4. Connect the tool to an air compressor using a 3/8" I.D. hose. Make sure the tool is not loaded and the
hose has a rated working pressure exceeding 200 PSI (13.8 BAR).
5. Regulate the air pressure to obtain 70 PSI (5 BAR) at the tool. Check the operation of the safety yoke
mechanism.
6. Insert fasteners into your tool following the instructions of loading the tool.
7. Reconnect the air hose to the tool.
8. Test for proper fastener penetration by driving fasteners into a piece of wood. If the
fastener penetration, regulate the air pressure to a higher setting until the desired
penetration is achieved. Do not exceed 120 PSI (8 BAR) at the tool
Operation Instruction
1. Thread the male plug onto the inlet bushing
2. Add 2 or 3 drops of non-detergent oil into the plug before each use
3. Connect to the air source with quick coupler
4. Choose qualified & correct impact socket and connect to the anvil
Advertisement
