Table of Contents
Advertisement
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS FLOOR FINISHING MACHINE.
To reduce the risk of fire, electric shock, or injury:
•
Your machine is equipped with a safety switch lock
and power switch triggers designed for your safety. Do
not attempt to bypass or defeat the safety switch lock.
Never use any device to lock the power switch triggers
in the "ON" position.
•
Do not leave the floor machine when plugged in. Turn
off the switch and unplug the electrical cord when not
in use and before servicing or changing the brushes or
pads.
•
Do not allow the machine to be used as a toy. Close
attention is necessary when used near children.
•
Do not leave the machine connected to an electrical
outlet unattended.
•
Use only as described in this manual. Use only
manufacturer's recommended attachments.
•
Do not use with a damaged cord or plug. If the
machine is not working as it should, has been dropped,
damaged, or left outdoors return it to a service center
before using.
•
Use care to keep the electrical supply cord from
contacting the rotating brush or drive block.
SAVE THESE INSTRUCTIONS
SERVICE INFORMATION
The instructions in this booklet serve as a guide to routine
maintenance. For additional service information, telephone
our toll free number for the nearest NCL Authorized
Warranty Station. You should know the model, type and
serial number or date code when you call:
USA: 1-800-628-2436
If you prefer, you can write to National Chemical
Laboratories, Inc. 401 North 10th Street, Philadelphia, PA
19123.
Refer to BLAZER MP Limited Warranty for complete
service information.
2
WARNING
•
Do not pull, close a door on, or pull the cord around
sharp edges or corners. Keep the cord away from
heated surfaces.
•
Connect to properly grounded (3-wire) outlet only
refer to Grounding Instructions, Pg 3.
•
Do not use extensions cords or outlets with
inadequate current carrying capacity.
•
Turn off all controls before unplugging.
•
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
•
Do not handle the plug or floor machine with wet
hands.
•
Wind the cord no tighter than is necessary to retain it
during storage. Refer to Cord Storage, Page 7.
•
Use extra care when working near stairs.
•
Do not use in conjunction with flammable or
combustible liquids such as gasoline, or use in areas
where explosive vapor or dust may be present.
•
Store your floor machine indoors in a cool, dry area.
•
Keep your work area well lighted.
•
Use indoors only.
DO NOT OIL the motor or the brush drive.
The motor and brush drive are permanently
sealed and lubricated.
Advertisement
Table of Contents
