Brush And Pad Driver Installation; Drive Belt Adjustment; Handle Adjustment - NCL 13” Blazer MP Owner's Manual

BRUSH AND PAD DRIVER INSTALLATION

CAUTION: Disconnect the power cord from the electrical
outlet before installing a brush or pad driver.
ON
To install a brush or pad driver, leave the handle in the
upright position and tip the machine backwards so it rests
on its wheels and upper handle section (Fig. 4). The brush
and pad driver both attach in the same manner: align
the cutouts on the inner ring of the brush or pad driver
with the tabs on the inside of the ring of the drive hub.
Push the brush or pad driver firmly in position, then turn it
counterclockwise until it locks into place.
To remove, turn the brush or pad driver clockwise until it
stops, then lift it off. Note: Always remove the brush or pad
driver when the machine is not in use.
4
OFF
Fig. 4
ADJUSTMENTS

DRIVE BELT ADJUSTMENT

CAUTION: Disconnect the power cord from the electrical
outlet before adjusting drive belt tension.
1. Loosen the bolts holding the drive motor to the frame;
do not remove (Fig. 5).
2. Turn the three screws at the rear of the frame until the
belt is tight.
3. Test the machine. If belt slips, adjust further. Retest. If
the belt does not slip, tighten the drive motor bolts. DO
NOT overtighten the drive belt.
Adjusting Bolts

HANDLE ADJUSTMENT

CAUTION: Disconnect the power cord from the electrical
outlet before installing a brush or pad driver.
The handle can be adjusted to any desired work position
by simply pushing up on the handle lock (Fig. 6). Move the
handle to the desired position, then firmly push down on
the handle lock which will lock the handle in position.
Unlock
Lock
Fig. 5
Fig. 6