Page 1
#1551 ACCELERATOR PEDESTAL #1571 ACCELERATOR WALL MOUNT GET STARTED A C C E L E R A T O R Professional Processor #1551 PEDESTAL #1571 WALL MOUNT ACCELERATOR WALL ARM PEDESTAL/STAND 4 STAR BASE comfortel.com.au...
7. Do not operate any electrical item with a damaged power cord. 2. Do not stop the accelerator head with your hands UNLESS it is an emergency Water poses a serious risk even 3. Always unplug the until before cleaning when device is switched off, do 4.
Page 3
OPERATION OPERATION 1. Adjust the accelerator into position (refer to diagram) 2. Turn POWER on 3. Select a MODE 4. Adjust TEMPERATURE and TIMER if required 5. Push START/STOP to commence treatment 6. During the operation changes can be made to the settings (but not the Mode) 7.
Page 4
INSTALLATION & ASSEMBLY: WALLMOUNT INSTALLATION OF WALL MOUNTED ACCELERATOR HEIGHT Recommended height of wall bracket is 1840mm-1950mm from the floor to the bottom of the bracket. ELECTRICAL A GPO must be installed within 500mm from the wall bracket. INSTALLATION OF THE WALL BRACKET STEM Using the wall bracket as the template, drill three holes (10.5mm...
Page 5
If the machine head hits the ceiling or other furniture, the height can be restricted. 1. Remove cover on arm 2. Turn the adjusting nut to the left as seen below. 3. If turn to the right, accelerator head can go higher 4. Lock tight after adjusting. TURN...
INSTALLATION & ASSEMBLY: PEDESTAL 3. INSTALL ACCELERATOR HEAD ON TO THE STAND WARNING DO NOT INSTALL GLIDE TUBE IN STAND PIPE WITHOUT ACCELERATOR HEAD. GLIDE TUBE MAY POP OUT RESULTING IN INJURY. GLIDE TUBE KNOB LEG ASSEMBLY LONG SIDE ADJUSTMENT...
#1571 ACCELERATOR WALL MOUNT Comfortel Furniture Pty Ltd. assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability VOLTAGE 230-240V and fitness for a particular purpose.
Need help?
Do you have a question about the ACCELERATOR and is the answer not in the manual?
Questions and answers