Installation - Blyss NDY-19MA-E Original Instructions Manual

Safety information / Before you start / Your product
Thermal Cut-Out
1. C AUTION! This product has one non-self-resetting overheat protection devices. In
the event that the heater stops working as a result of overheating take the following
immediate steps: switch the electricity off at the socket and remove the plug. Remove
any objects that are covering the product.
2. C AUTION! Do not touch the heater as it will be hot.
3. Set the heater switches to O (off position) and leave the heater to cool. Once
completely cool, reconnect the heater and switch it on.
Things to check before you start
1. For domestic use only.
2. Never allow children or persons unable to operate the appliance safely to use this
appliance without supervision.
3. Please dispose of plastic bags carefully and keep them away from children.
4. IMPORTANT: When in use never cover the heater in any way or place it close to
combustible materials. The heater will get hot, never touch it whilst in use. Always
keep children and pets at a safe distance and never leave unsupervised in a room
with a heater that is working.
Your product
[A] x 2
[B] x 2
6
[01] x 1
[02] x 1
[C] x 4 [D] x 2
NDY-19MA-E NDY-19MA-E
Assembly
> This product comes fully assembled, before using please ensure that all components
and fixings are secure, and make sure the appliance is in perfect condition before
operation.
You will need
Screwdriver x 1
AAA 1.5V Battery x 2
Intended use
1. This product is intended for indoor use only. It is not intended for commercial use.
2. This product is intended for fixed installation only. Do not use it as a free standing
heater.
3. This product contains no user serviceable parts and requires little maintenance.
Leave any servicing or repairs to qualified personnel only. The LEDs contained in
this product are non-replaceable.
4. Before connecting the appliance to the power supply, check that the power supply
voltage and current rating corresponds with the power supply details shown on the
appliance rating label.

Installation

Installation steps (page 7-8)
> Ensure that the appliance is switched off and disconnected from the socket outlet.
CAUTION! Make sure not to damage any wiring that could be potentially behind
the back panel e.g. mantel.
1. Secure the appliance to the wall using the supplied brackets and screws.
2. Press each bracket against the inside wall of the appliance, ensuring that the bracket
is located as high as possible.
3. Mark the location of the 2 holes on the inside wall.
4. Carefully drill two 5 mm deep holes using a 2 mm drill bit. Do not exceed 5 mm depth
to prevent damage to the outside surface of the appliance. This hole is to ensure
that you do not crack the wood when using the self tapping screws to fix the bracket
onto the appliance.
5. Place the bracket on the 2 holes and secure it in place with 2 screws (C).
Your product / Installation
7