LaserLiner CompactPlane-Laser 3D Manual page 12

2
Horizontal and vertical levelling
Release the transport restraint, set slide switch (3) to "ON". The horizontal
laser line appears. The laser lines can be switched on individually with the
selection button.
LASER
The transport restraint must be released for horizontal and vertical
!
levelling. The laser lines flash and a signal sounds as soon as the device
is outside the automatic levelling range of 3.5°. Position the device
such that it is within the levelling range.
3
Slope mode
Do not release the transport restraint, set slide switch (3) to "OFF". Press
button (5) for 5 seconds to switch on slope mode. The lasers can now be
selected with the selector button (5). Sloping planes and tilts can now be
measured. In this mode, the laser lines no longer align automatically.
LASER
12
GB
LASER LASER
LASER LASER
LASER
LASER